Pages maintained by Rattlebars Mfg. Support our affiliates! Click above!
The information on these pages is accurate to the best of the author's knowledge. The author can assume no responsibility for the use or misuse of this information by the reader. The reader is expected to secure any other information needed from Service Manuals or other sources. It is up to the reader to determine his/her ability to make any modifications noted. If the reader does not feel qualified he/she should enlist professional help.

Memphis Shades Hellcat
Fittin with my theme of minimal bulk maximum function
but sometimes I need a shield for cold or distance..

When I need a shield, I run the Memphis Shades Hellcat. Gives pretty good protection without making you feel like you're riding in your car (note that I HATE shields and fairings so if you don't like ANYwind you won't like this). Pops off in seconds and leaves little evidence that it was once there. Top of shield is about at my nose and the tilt is critical so that the air coming off is not turbulent. The clamps and all hardware are highly polished using the methods described on my Conehead Bolt Polishing pages.

 

Nephew Joe's VTX with Hellcat on it.


Questions? Contact Chet at Chet says 'Be sure to write!'Chetspages@rattlebars.com

Chet's Valkyrie Pages Rattlebars Mfg. Chet's VTX Pages